Plate Bending Machine PR-10500-4CNC

This plate roller has the same rigid steel structure as its sister models (PR-10500-4 and PR-10500-4NC) but incorporates a CNC touchscreen controller specially designed for Baileigh.

• Made in Italy and refined through years of research.
• ½” mild steel capacity.
• 120” (10-foot) length.
• Large 10 hp motor runs on 480-volt 3-phase power.

Forming Rolls and Hydraulics

• All 4 forming rolls are hardened and polished.
• 2 central driven rolls.
• Dual hydraulic motors and high-efficiency planetary gearboxes directly rotate the 2 driven rolls.
• 4-roll design pinches the plate between the 2 driven rolls, pre-bends the leading edge, and rolls the part along with the trailing edge in one pass.
• Front rolls have independent hydraulic lifters that go in the orbital pattern.
• Stabilizer torsion bar system keeps front rolls parallel to the top roll.
• Plate is pinched at all times during the rolling cycle, so there’s no chance to lose the position.
• You can adjust the angle of the rolls and bend cones.
• Hydraulic system for material removal: yoke on top roll drops, allowing the roll to lift.

CNC Programmer and Control Panel

Warranty and After-Care

• Covered by a 1-year parts warranty.
• Comes with lifetime technical support by phone from our in-house team of knowledgeable reps.
• Free machine training and demos are available at our Wisconsin headquarters. Optional training at your location is available for a fee.

Also available in a non-NC version, the PR-10500-4, and a numerically controlled version PR-10500-4NC.

Questions? Not sure which plate roll is right for you? Call 1-920-684-4990 and talk to a Baileigh expert.